A Ruger SP is likely in my future. I learned of a series of books called IBOK’s ( Iowegan’s Books of Knowledge). They used to be available for. I bought a new SP a few days ago, did the IBOK action smoothing, and then decided to try giving it a mirror polish. I have a lot of experience. Post subject: SP mods. Post . He re-did the IBOK, removed the offending schematic and added LOTS more pics and now he charges for it.
|Published (Last):||8 January 2011|
|PDF File Size:||2.36 Mb|
|ePub File Size:||14.69 Mb|
|Price:||Free* [*Free Regsitration Required]|
The spring-loaded plunger may launch so keep you thumb in position until the latch is all the way out.
Ream the empty chamber then switch cases to expose another chamber until all are chamfered. GPs have been produced in both blued and stainless steel models.
The SP Club – Page 24
I also would be interested in the SP and GP books. When sanding, your goal is to smooth the rough spots while removing as little metal as possible. Not as good as night sights, but as good as I ibokk afford right now. The firing pin is secured by a recoil plate part 31 and held ibol place by a recoil plate cross pin part They have a greater selection of sights than about anyone.
Instead of energy being efficiently transferred to the firing pin, much of the energy is wasted. This is first revolver and I think I’ll buy more. I have a question regarding references to photos and page numbers. Smoothed everything up but left the factory springs in it for reliability because it is a carry piece. Add Thread to del.
The SP101 Club
You can leave a responseor trackback from your own site. Optimizing for lead bullets: Inspect it carefully and remove any burrs from the lock lip in the front. Insert the crane shaft into the frame hole while holding the cylinder in the open position.
The GP has a larger frame, thicker cylinder, improved grip mounting system, trigger return spring, ap101 sight, internal cylinder retainer, and trigger guard latch. I biok test fired the gun yet after doing the work. It looks much better and is much easier to read and follow. A spring kit is available from http: On a Security Six I used to own, the hammer seemed like a kind of generic part, in and of itself a separate part.
The GP has been manufactured in several configurations but the internal parts are all interchangeable. I have a trigger job done by a gunsmith, and the trigger is much lighter and smoother now.
I find it helpful to label the parts during disassembly. There are only a few materials of real value and yours is number one!
Ruger SP101 IBOK
Any rough spot will cause the pawl to dig in, make DA trigger pull raspy, and will wear the tip of the pawl. You can open the throats to. RuminatorDec 17, Cut off the end of the gauge and drill or punch a hole slightly larger than the pin that’ll go in the hole.
Grips are interchangeable between all models and are also the same as Ruger Super Redhawk grips. GP Wolff Spring Weight? Adjustable sight ibko are available in 4 and 6 inch barrels.
Ruger SP Modifications
I started the blog because I found so much misinformation and just poor info I decided I would put as much info on the blog as I could after making sure of my sources plus my own experience over s1p01 years. Does anyone have experiences using Wolff hammer springs for the SP? S1p01 front latch part 13latch plunger part 26and latch plunger spring part 4 will fall out. He has authored numerous 2 that I know of, heh books e-books, if you like about fine handguns.
You can safely take.